Download Aruba Certified Switching Associate Exam.HPE6-A72.ExamTopics.2026-05-05.89q.vcex

Vendor: HP
Exam Code: HPE6-A72
Exam Name: Aruba Certified Switching Associate Exam
Date: May 05, 2026
File Size: 5 MB
Download Exam

How to open VCEX files?

Files with VCEX extension can be opened by ProfExam Simulator.

Download
ProfExam Simulator

Purchase
Coupon: EXAMFILESCOM

Discount: 20%

ProfExam Simulator ProfExam Simulator ProfExam Simulator ProfExam Simulator ProfExam Simulator
ProfExam Discount

Demo Questions

Question 1
Which two statements are true about the state of a new HPE Aruba Networking CX 6300 Series switch on factory defaults? (Choose two.)
  1. The CX 6300M has support for IP addressing applied to switched virtual interfaces (SVIs) but not on routed ports
  2. LLDP is enabled on up-link ports and switchports for the CX 6300M
  3. For the CX 6300M switch, all up-link ports and switchports are configured as access mode
  4. The CX 6300M up-link ports only support routed mode. All other ports only support access mode
  5. LLDP is not enabled but is supported on ail AOS-CX switches
Correct answer: B, C
Question 2
Refer to the exhibits.
The AOS-CX 6300M switch is attempting to configure VSF with a peer CX 6300F switch. What is one reason you are receiving the above error when attempting to configure VSF on the AOS-CX 6300M switch?
  1. The port 1/1/21 has been shutdown.
  2. AOS-CX VSF links can only be applied to uplink ports with 10G, 25G, and 50G speeds.
  3. Link 1 cannot be used if the attached CX 6300F VSF member 2 has already assigned link 1.
  4. VSF is not possible between CX 6300M and CX 6300F AOS-CX switches.
Correct answer: B
Question 3
Refer to the exhibit.
All switches shown are CX 6300M. The links connecting SW3 to both SW1 and SW2 are broken. Multi-Active Detection has not been enabled. What are two results? (Choose two.)
  1. The stack wall split resulting in SW1 remaining an active VSF Master and SW3 disabling all ports. SW2 will automatically take the VSF Standby role.
  2. A re-election will occur upon repairing the disabled links between SW2 and SW3. The switch with the highest priority will reclaim the Master role with the lowest bridge mac-address acting the tie-breaker.
  3. The OSPF adjacency between the OSPF neighbor and the VSF stack switches (SW2 and SW3) will remain up. Packets destined for SW3 that are received on SW2 are discarded.
  4. The stack will split with SW1 remaining an active VSF Master and SW3 becoming another active VSF Master. Switch 2 will remain a VSF member switch.
  5. Only the OSPF adjacency between SW3 and the OSPF neighbor will fail. All routed traffic will be redirected to SW2 instead.
Correct answer: A, D
Question 4
Match each description to the correct management tool for Aruba AOS-CX.
Correct answer: To work with this question, an Exam Simulator is required.
Question 5
Place the OSI Layers in the correct order. Arrange them from least to greatest, starting with Layer 1 on the top, and progressing to Layer 7 on the bottom.
Correct answer: To work with this question, an Exam Simulator is required.
Question 6
What are two features in a 2-Tier design that are implemented at the Access layer? (Choose two.)
  1. VPN access
  2. WAN/MPLS connectivity
  3. Endpoint Access
  4. Deep packet inspection
  5. Power over Ethernet
Correct answer: C, E
Question 7
Refer to the exhibit -
What is true regarding VLAN 50 according to the diagram above?
  1. VLAN 50 is part of a switched virtual interface (SVI) that was never routed causing it to be down.
  2. Since VLAN 50 has not been assigned to any enabled physical port, the status is down.
  3. VLAN 50 is assigned only to Trunk ports which is why no ports are listed under interfaces.
  4. VLAN 50 was never added to the vlan-database and therefore is in a down state.
Correct answer: B
Question 8
Interface 1/1/1 is up -
Admin state is up -
Link transitions: 1 -
Description: TO_PC-1 -
Hardware: Ethernet, MAC Address: 00:11:22:33:44:55
MTU 1500 -
Type 1GbT -
Full-duplex -
qos trust none
Speed 1000 Mb/s -
Auto-negotiation is on -
Flow-control: off -
Error-control: off -
MDI mode: MDIX -
VLAN Mode: access -
Access VLAN: 1111 -
Which command will produce the above output?
  1. show interface vlan 1111
  2. show interface 1/1/1
  3. show interface gigabit 1/1/1
  4. show vlan 1111
Correct answer: B
Question 9
The customer has 778 developers testing computer games on the network.
Which two actions resolve Broadcast storms? (Choose two.)
  1. Manually disable the redundant link to immediately resolve the impacted portion of the network.
  2. Utilize Spanning Tree to dynamically disable all redundant links in a segment.
  3. Setting switch ports to half-duplex will resolve Broadcast storms using Carrier Sense Multiple-Access Collision Detection (CSMA/CD).
  4. Enable single Area Open Shortest Path First (OSPF) on all Layer 2 switches, but do not enable routing.
  5. Utilize Spanning Tree to dynamically block Designated ports in addition to Alternate ports.
Correct answer: A, B
Question 10
Refer to the exhibit.
The above output is the result of issuing the command show system resource-utilization.
What command should be used to enable terminal output line by line or page by page?
  1. The command page
  2. The command terminal length 30
  3. The command more
  4. The command less
Correct answer: A
Question 11
Refer to the exhibit.
LLDP -
The command show LLDP neighbor-info gets typed into Access-1. All switches are Aruba OS-CX switches.
What is the output of this command?
Correct answer: D
CONNECT US
HOW TO OPEN VCE FILES

Use VCE Exam Simulator to open VCE files
Avanaset

HOW TO OPEN VCEX AND EXAM FILES

Use ProfExam Simulator to open VCEX and EXAM files
ProfExam Screen

ProfExam
ProfExam at a 20% markdown

You have the opportunity to purchase ProfExam at a 20% reduced price

Get Now!