Download CCNA Cisco Certified Network Associate CCNA (v3-0).pass4sures.200-125.2019-03-23.1e.621q.vcex
Download Exam
File Info
| Exam | CCNA Cisco Certified Network Associate CCNA (v3.0) |
| Number | 200-125 |
| File Name | CCNA Cisco Certified Network Associate CCNA (v3-0).pass4sures.200-125.2019-03-23.1e.621q.vcex |
| Size | 29.46 Mb |
| Posted | March 23, 2019 |
| Downloads | 674 |
How to open VCEX & EXAM Files?
Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.
Coupon: EXAMFILESCOM
With discount: 20%
Demo Questions
Question 1
Refer to the exhibit.
All of the routers in the network are configured with the ip subnet-zero command.
Which network addresses should be used for Link A and Network A? (Choose two.)
All of the routers in the network are configured with the ip subnet-zero command.
Which network addresses should be used for Link A and Network A? (Choose two.)
- A: Link A – 172.16.3.0/30
- B: Link A – 172.16.3.112/30
- C: Network A – 172.16.3.48/26
- D: Network A – 172.16.3.128/25
- E: Link A – 172.16.3.40/30
- F: Network A – 172.16.3.192/26
Question 2
Which type of device can be replaced by the use of subinterfaces for VLAN routing?
- A: Layer 2 bridge
- B: Layer 2 switch
- C: Layer 3 switch
- D: router
Question 3
What are two benefits of private IPv4 IP addresses? (Choose two.)
- A: They are routed to the Internet the same as public IP addresses.
- B: They are less costly than public IP addresses.
- C: They can be assigned to devices without Internet connections.
- D: They eliminate the necessity for NAT policies.
- E: They eliminate duplicate IP conflicts.
Question 4
Which three statements about IPv6 prefixes are true? (Choose three.)
- A: FEC0::/10 is used for IPv6 broadcast.
- B: FC00::/7 is used in private networks.
- C: FE80::/8 is used for link-local unicast.
- D: FE80::/10 is used for link-local unicast.
- E: 2001::1/127 is used for loopback addresses.
- F: FF00::/8 is used for IPv6 multicast.
Question 5
Refer to the exhibit.
The network administrator cannot connect to Switch 1 over a Telnet session, although the hosts attached to Switch1 can ping the interface Fa0/0 of the router. Given the information in the graphic and assuming that the router and Switch2 are configured properly, which of the following commands should be issued on Switch1 to correct this problem?
The network administrator cannot connect to Switch 1 over a Telnet session, although the hosts attached to Switch1 can ping the interface Fa0/0 of the router. Given the information in the graphic and assuming that the router and Switch2 are configured properly, which of the following commands should be issued on Switch1 to correct this problem?
- A: Switch1(config)# ip default-gateway 192.168.24.1
- B: Switch1(config)# interface fa0/1
Switch1(config-if)# switchport mode trunk - C: Switch1(config)# line con0
Switch1(config-line)# password cisco
Switch1(config-line)# login - D: Switch1(config)# interface fa0/1
Switch1(config-if)# ip address 192.168.24.3 255.255.255.0 - E: Switch1(config)# interface fa0/1
Switch1(config-if)# duplex full
Switch1(confiq-if)# speed 100
Question 6
Which two statements about wireless LAN controllers are true? (Choose two.)
- A: They can simplify the management and deployment of wireless LANs.
- B: They rely on external firewalls for WLAN security.
- C: They are best suited to smaller wireless networks.
- D: They must be configured through a GUI over HTTP or HTTPS.
- E: They can manage mobility policies at a systemwide level.
Question 7
Which step in the router boot process searches for an IOS image to load into the router?
- A: mini-IOS
- B: ROMMON mode
- C: bootstrap
- D: POST
Question 8
Which protocol advertises a virtual IP address to facilitate transparent failover of a Cisco routing device?
- A: FHRP
- B: DHCP
- C: RSMLT
- D: ESRP
Question 9
Refer to the exhibit. Which command can you enter to verify link speed and duplex setting on the interface?
- A: router#show ip protocols
- B: router#show startup-config
- C: router#show line
- D: router#show interface gig 0/1
Question 10
Which functionality does split horizon provide?
- A: It prevents switching loops in distance-vector protocols.
- B: It prevents switching loops in link-state protocols.
- C: It prevents routing loops in distance-vector protocols.
- D: It prevents routing loops in link-state protocols.
HOW TO OPEN VCEX AND EXAM FILES
Use ProfExam Simulator to open VCEX and EXAM files
HOW TO OPEN VCE FILES
Use VCE Exam Simulator to open VCE files
