Download Interconnecting Cisco Networking Devices Part 1 (ICND1 v3-0).selftesttraining.100-105.2018-10-01.1e.363q.vcex

Download Dump

File Info

Exam Interconnecting Cisco Networking Devices Part 1 (ICND1 v3.0)
Number 100-105
File Name Interconnecting Cisco Networking Devices Part 1 (ICND1 v3-0).selftesttraining.100-105.2018-10-01.1e.363q.vcex
Size 10.81 Mb
Posted October 01, 2018
Downloaded 106



How to open VCEX & EXAM Files?

Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.

Purchase
Coupon: EXAMFILESCOM

Coupon: EXAMFILESCOM
With discount: 20%





Demo Questions

Question 1
Which network configuration can you use to segregate broadcast traffic for two different departments in your organization?

  • A: Configure two VTP domains and configure the switches in transparent mode.
  • B: Enable spanning-tree load balancing.
  • C: Implement switch port security on designated ports.
  • D: Configure a separate VLAN for each department.



Question 2
Which keyword in a NAT configuration enables the use of one outside IP address for multiple inside hosts?

  • A: source
  • B: static
  • C: pool
  • D: overload



Question 3
Which NAT term is defined as a group of addresses available for NAT use?

  • A: NAT pool
  • B: dynamic NAT
  • C: static NAT
  • D: one-way NAT



Question 4
  

Refer to the exhibit. The enterprise has decided to use the network address 172.16.0.0. The network administrator needs to design a classful addressing scheme to accommodate the three subnets, with 30, 40, and 50 hosts, as shown. Which subnet mask would accommodate this network?

  • A: 255.255.255.224
  • B: 255.255.255.240
  • C: 255.255.255.252
  • D: 255.255.255.248
  • E: 255.255.255.192



Question 5
  

Refer to the exhibit. The network administrator is testing connectivity from the branch router to the newly installed application server. 
Which reason is the most likely for the first ping having a success rate of only 60 percent?

  • A: The branch router LAN interface should be upgraded to FastEthernet.
  • B: The branch router had to resolve the application server MAC address.
  • C: The network is likely to be congested, with the result that packets are being intermittently dropped.
  • D: There is a short delay while NAT translates the server IP address.
  • E: A routing table lookup delayed forwarding on the first two ping packets.



Question 6
  

Refer to the topology and switching table shown in the graphic. Host B sends a frame to Host C. Which option describes what the switch will do with the frame?

  • A: send an ICMP Host Unreachable message to Host B
  • B: return the frame to Host B
  • C: drop the frame
  • D: send the frame out all ports except port 0/2
  • E: record the destination MAC address in the switching table and send the frame directly to Host C
  • F: send an ARP request for Host C



Question 7
An administrator has connected devices to a switch and, for security reasons, wants the dynamically learned MAC addresses from the address table added to the running configuration. Which action must be taken to accomplish this?

  • A: Use the no switchport port-security command to allow MAC addresses to be added to the configuration.
  • B: Enable port security and use the keyword sticky.
  • C: Set the switchport mode to trunk and save the running configuration.
  • D: Use the switchport protected command to have the MAC addresses added to the configuration.



Question 8
Which port-security feature allows a switch to learn MAC addresses dynamically and add them to the running configuration?

  • A: security violation restrict mode
  • B: switch port protection
  • C: sticky learning
  • D: security violation protect mode



Question 9
Which statement about 6to4 tunneling is true?

  • A: One tunnel endpoint must be configured with IPv4 only.
  • B: Both tunnel endpoint must be configured with IPv4 only.
  • C: It establishes a point-to-point tunnel.
  • D: Both tunnel endpoints must support IPv4 and IPv6.



Question 10
An administrator is working with the 192.168.4.0 netwrok, which has been subnetted with a /26 mask. 
Which two addresses can be assigned to hosts within the same subnet? (Choose two.)

  • A: 192.168.4.67
  • B: 192.168.4.61
  • C: 192.168.4.128
  • D: 192.168.4.132
  • E: 192.168.4.125
  • F: 192.168.4.63









CONNECT US


ProfExam
PROFEXAM WITH A 20% DISCOUNT

You can buy ProfExam with a 20% discount..

Get Now!


HOW TO OPEN VCEX AND EXAM FILES

Use ProfExam Simulator to open VCEX and EXAM files
ProfExam Screen



HOW TO OPEN VCE FILES

Use VCE Exam Simulator to open VCE files
Avanaset