Download Cisco.PracticeDumps.400-201.2018-01-07.1e.100q.vcex

Download Dump

File Info

Exam CCIE Service Provider Written Exam
Number 400-201
File Name Cisco.PracticeDumps.400-201.2018-01-07.1e.100q.vcex
Size 5.55 Mb
Posted January 07, 2018
Downloads 38


How to open VCEX & EXAM Files?

Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.

Download
ProfExam Simulator

Purchase
Coupon: EXAMFILESCOM

Coupon: EXAMFILESCOM
With discount: 20%


ProfExam Simulator ProfExam Simulator ProfExam Simulator ProfExam Simulator ProfExam Simulator


Demo Questions

Question 1
Which Cisco IOS XR Virtualization technology provides full isolation between virtualized routing instances for extra control plane resources?

  • A: DRP
  • B: SDR
  • C: SVR
  • D: HVR
Correct Answer: B
References:



Question 2
Which are the three characteristics of SDR? (Choose three.)

  • A: The logical router has dedicated route processor.
  • B: Owner SDR can be reloaded without affecting all non-SDRs.
  • C: The fabric and system controller module are shared by all logical routers.
  • D: The logical router can share line cards.
  • E: The logical router can span across chassis.
  • F: Each logical router has a distinct fabric and system controller module.
Correct Answer: ACE



Question 3
Which are the two advantages of Cisco IOS XR Software over Cisco IOS Software? (Choose two.)

  • A: a monolithic OS
  • B: a configuration that is grouped by interface
  • C: one-stage configuration
  • D: a two-stage configuration
  • E: a configuration that is grouped by process
Correct Answer: DE



Question 4
On Cisco IOS XR platform, why would an engineer use the load rollback command instead of the rollback command?

  • A: to revert commits with IDs 100000005 10000007 simultaneously.
  • B: to revert a change even after a subsequent change is made.
  • C: to revert changes to RLP objects.
  • D: to revert changes to admin mode configuration.
Correct Answer: A



Question 5
Which are the three key design requirements for mobile IP backhaul? (Choose three.)

  • A: MPLS-enabled interface
  • B: network timing distribution and recovery
  • C: mandatory Layer 3 access up to a cell site
  • D: X2 interface turning point
  • E: native IPv6 support
  • F: bandwidth
Correct Answer: BCE



Question 6
Which two options are considered nodes in Low-power Lossy Networks? (Choose two.)

  • A: routers
  • B: access points
  • C: controllers
  • D: sensors
  • E: servers
Correct Answer: AD



Question 7
Drag and drop the subslot of the SIP-800 card that is used on Cisco CRS routers on the left onto the correct PLIM ASIC process on the right. 



Correct Answer: Exam simulator is required



Question 8
A service provider is implementing an nV Edge system with two Cisco ASR 9000 chassis. Each chassis has two RSPs. Which two cabling methods reflect the minimum configuration needed for full synchronization between the two Cisco ASR 9000 chassis? (Choose two.)

  • A: Create the IRL connections between the two chassis via Layer 1 connections using the EOBC 10 Gbps ports of the RSPs.
  • B: Create the single virtual control plane that connect the two chassis via Layer 3 connections using the 10 Gbps ports of the line cards.
  • C: Create the IRL connections between the two chassis via Layer 1 connections using the 10 Gbps ports of the line cards.
  • D: Create the single virtual control plane that connect the two RPS between the two chassis via Layer 2 connections.
  • E: Create the IRL connections between the two chassis via Layer 3 connections using the ports ofthe line cards.
  • F: Create the IRL connections between the two chassis via Layer 3 connections using the EOBC 10 Gbps ports of the RSPs.
  • G: Create the single virtual control plane that connect the two chassis via 100 Gbps bundle interfaces.
Correct Answer: CD
References:



Question 9
A service provider is using Cisco ME 3400 Series Ethernet Access Switches on the access edge of Metro Ethernet POP. A customer has a requirement to connect a switch to the network and requires the ability to trunk VLANs on the uplink port into the provider network. 
Which port type should the engineer configure on the switch to meet the requirement while maintaining a secure success edge implementation?

  • A: UNI
  • B: ENI
  • C: NNI
  • D: access
Correct Answer: B



Question 10
Drag and drop the SONET alert types on the left onto the correct severities on the right. Not all options are used. 

 

Correct Answer: Exam simulator is required









CONNECT US


ProfExam
PROFEXAM WITH A 20% DISCOUNT

You can buy ProfExam with a 20% discount..

Get Now!


HOW TO OPEN VCEX AND EXAM FILES

Use ProfExam Simulator to open VCEX and EXAM files
ProfExam Screen



HOW TO OPEN VCE FILES

Use VCE Exam Simulator to open VCE files
Avanaset