Download Implementing Cisco Enterprise Wireless Networks (300-430 ENWLSI).train4sure.300-430.2020-01-09.1e.26q.vcex


Download Exam

File Info

Exam Implementing Cisco Enterprise Wireless Networks (300-430 ENWLSI)
Number 300-430
File Name Implementing Cisco Enterprise Wireless Networks (300-430 ENWLSI).train4sure.300-430.2020-01-09.1e.26q.vcex
Size 220 Kb
Posted January 09, 2020
Downloads 27



How to open VCEX & EXAM Files?

Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.

Purchase
Coupon: EXAMFILESCOM

Coupon: EXAMFILESCOM
With discount: 20%


 
 



Demo Questions

Question 1
You are designing a WLAN for 50 branch offices that require central management. Which controller architecture do you use?

  • A: per-branch local controllers
  • B: anchor controllers
  • C: FlexConnect controllers
  • D: autonomous access points



Question 2
A customer reports that wireless clients are not able to receive multicast data from known working multicast servers on the wired network. The client is connecting at the highest mandatory wireless rate of 24 Mbps and the wireless controller is configured for multicast-unicast mode. What three actions should the engineer take next to troubleshoot the issue? (Choose three.)

  • A: verify that the L3 interfaces are configured for pim sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller's management VLAN
  • B: change the wireless controller from Multicast-Unicast mode to Multicast-Multicast mode and assign a multicast address in the 239.X.X.X/8 subnet
  • C: verify that IGMP snooping is disabled on the wireless controller since the access points are handling IGMP messages from the clients
  • D: verify that Global Multicast mode has been enabled
  • E: make sure the highest mandatory rate is set to 54 Mbps so that the multicast traffic has sufficient bandwidth
  • F: verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows



Question 3
An engineer is tuning RRM parameters to improve client connectivity. Which channel band results in the best 802.11n client compatibility?

  • A: UNII-2
  • B: UNII-2e
  • C: UNII-3
  • D: UNII
  • E: UNII-1



Question 4
A downstream packet that contains a DSCP value arrives at the WLC Ethernet interface from the wired source network. The WLC is configured for QoS WLAN 802.1p mapping. How does the WLC treat the CAPWAP QoS marking when leaving the controller interface for the respective AP and final wireless client destination?

  • A: No outer CAPWAP or inner QoS tagging is applied.
  • B: The outer CAPWAP CoS is marked and capped and the inner DSCP maintains the original marking.
  • C: No outer CAPWAP QoS tag is applied, but the original DSCP is maintained inside CAPWAP.
  • D: The outer CAPWAP DHCP is marked and capped without any inner DSCP value.



Question 5
An engineer is deploying centralized wireless solution with a 5508 controller. What is the most AP licenses that can be supported?

  • A: 100
  • B: 250
  • C: 1000
  • D: 500



Question 6
Which list of characteristics must all controllers in a mobility group have in common based on best practices?

  • A: mobility group name, version of controller code, Control and Provisioning of Wireless Access Points mode, ACLs, and WLANs (SSIDs)
  • B: mobility domain name, version of controller code, and Control and Provisioning of Wireless Access Points mode
  • C: mobility domain name, version of controller code, Control and Provisioning of Wireless Access Points mode, ACLs, and WLANs (SSIDs)
  • D: mobility group name, version of controller code, and Control and Provisioning of Wireless Access Points mode



Question 7
An engineer is conducting a location readiness test and wants a selected point to be considered location-ready. Which three possible configurations reflect the minimum number of APs needed? (Choose three.)

  • A: One AP is resident in each quadrant surrounding the point-in-question.
  • B: One AP per 1400 sq. ft. on the map.
  • C: Two APs are resident in each quadrant surrounding the point-in-question.
  • D: Four APs are deployed on the floor.
  • E: Three APs are within 70 feet (21 meters) of the point-in-question.
  • F: Three APs are deployed on the floor.



Question 8
Which two best practices should be considered when a customer wants to purchase and implement Voice over Wireless for Cisco 7925 IP Phones? (Choose two.)

  • A: Enable lower data rates for 2.4-GHz data WLAN and higher data rates for phones.
  • B: Use a separate Cisco Wireless Lan Controller.
  • C: Enable 802.1x and Cisco Centralized Key Management for phone authentication.
  • D: Use dedicated Access Points only for Voice over Wireless.
  • E: Set data for 2.4 GHz and voice for 5 GHz using separate SSIDs.



Question 9
Which three things do you need to consider prior to performing a wireless site survey? (Choose three.)

  • A: The time required to acquire any additional infrastructure components.
  • B: The time required to survey each potential AP location.
  • C: The time required to assess application server locations at the customer facility.
  • D: The type of wireless survey tools required to perform the site survey.
  • E: The time required to assess customer WLAN density and throughput requirements.
  • F: The time required to utilize the design mode in Cisco WCS to prepare a preliminary WLAN design to reduce on-site survey time.



Question 10
Which type of information should be included in an installation report?

  • A: A complete characterization of the external WLAN environment.
  • B: The exact number of users the WLAN will support.
  • C: Soft copies of configuration for switches, routers, controllers, and location appliances.
  • D: A detailed description of the WLAN environment during the post-installation testing, for example, number of people present, furniture, no furniture, and sources of interference present.








ProfExam
PROFEXAM WITH A 20% DISCOUNT

You can buy ProfExam with a 20% discount..

Get Now!


HOW TO OPEN VCEX AND EXAM FILES

Use ProfExam Simulator to open VCEX and EXAM files
ProfExam Screen



HOW TO OPEN VCE FILES

Use VCE Exam Simulator to open VCE files
Avanaset