Download Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI).PrepDumps.300-410.2021-05-27.1e.131q.vcex


Download Exam

File Info

Exam Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI)
Number 300-410
File Name Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI).PrepDumps.300-410.2021-05-27.1e.131q.vcex
Size 5.48 Mb
Posted May 27, 2021
Downloads 24



How to open VCEX & EXAM Files?

Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.

Purchase
Coupon: EXAMFILESCOM

Coupon: EXAMFILESCOM
With discount: 20%


 
 



Demo Questions

Question 1
An automatic IPv4-compatible IPv6 tunnel exists between two IPv6 networks. The two IPv6 networks belong to different BGP autonomous systems (AS). The tunnel source has the IPv4 address 172.168.111.65/24 and the tunnel destination has the IPv4 address 172.168.222.80/24. 
Which of the following statements is TRUE about the tunnel source and tunnel destination IPv6 addresses? (Choose two.)

  • A: the IPv6 address of the tunnel source is 172.168.111.65::
  • B: the IPv6 address of the tunnel source is ::172.168.111.65
  • C: the IPv6 address of the tunnel destination is 172.168.222.80::
  • D: the IPv6 address of the tunnel destination is ::172.168.222.80



Question 2
Your company has implemented IPv6 addresses and routing on every host, server, and router. Recently, your company acquired another company that has an IPv4 addressing scheme for its entire network. The acquired company's network does not have any support for IPv6. You need to devise a method so that the IPv6 hosts in your company can seamlessly communicate with the IPv4 hosts of the acquired company's network. You do not want to install any additional routers, and you want minimum configuration changes on the networks. Which of the following is the best method to allow communication between the IPv4 and IPv6 hosts?

  • A: Embedding IPv6 packets into IPv4 packets 
  • B: Translating IPv4 addresses to and from IPv6 addresses
  • C: Configuring IPv6 on the hosts and routers in the IPv4 network
  • D: ConfiguringIPv4 on the hosts and routers in the IPv6 network



Question 3
Which of the following statements are TRUE about manually configured IPV4-to-IP6 tunnels and GRE tunnels? 
(Choose two.)

  • A: Manually configured tunnels use the tunnel mode ipv6ip command, while GRE tunnels use the tunnel mode gre ip command.
  • B: Manually configured tunnels support IPv6 IGPs, while GRE tunnels do not.
  • C: Manually configured tunnels block IPv6 multicasts, while GRE forwards them.
  • D: Manually configured tunnels do not support multiple passenger protocols, while GRE tunnels support them.



Question 4
Which dialer interface command sets the maximum size of IP packets to 1492?

  • A: router(config-if)# mtu 1492
  • B: router(config-if)# ip ppp 1492
  • C: router(config-if)# ip 1492 
  • D: router(config-if)# ip mtu 1492



Question 5
Examine the following FIB table:

    

Which of the following statements is NOT true?

  • A: These are the default entries in an FIB table
  • B: No IP addresses have been configured on this router
  • C: Multicast routing is enabled
  • D: The gateway of last resort has not been set



Question 6
Which of the following IPv6/IPv4 interoperability techniques routes both IP versions simultaneously?

  • A: NAT-PT
  • B: Dual stack
  • C: 6to4 tunnels
  • D: Teredo



Question 7
Which of the following statements represent characteristics of an automatic 6to4 tunnel through an IPv4 network? (Choose all that apply.)

  • A: There is a NAT-PT router on either end of the tunnel.
  • B: There is a dual stack router on either end of the tunnel.
  • C: Each 6to4 site will have a /48 prefix. 
  • D: Each 6to4 site will have a /16 prefix.
  • E: The IPv4 addresses of the edge routers are part of the site prefix.
  • F: The IPv6 addresses of the sending and receiving IPv6 hosts are part of the site prefix.



Question 8
Examine the following output. 

    

What possible reason(s) can cause the state of the first entry in the adjacency table? (Choose all that apply.)

  • A: the interface is a multipoint interface
  • B: the clear ip arp command was executed
  • C: the Layer 3 information is unknown
  • D: the clear adjacency command was executed



Question 9
You have been alerted that TCP traffic leaving an interface has been reduced to near zero, while UDP traffic is steadily increasing at the same time.  
What is this behavior called and what causes it?

  • A: jitter, caused by lack of QoS
  • B: latency, caused by the MTU
  • C: starvation, caused improper configuration of QoS queues
  • D: windowing, caused by network congestion



Question 10
Refer to the following set of commands:

    

Which of the following statements is TRUE about the given set of commands?

  • A: IPv4 and IPv6 are running simultaneously on rtrA
  • B: The IPv4 address is translated to an IPv6 address
  • C: The IPv6 address is an IPv4-compatible address
  • D: A tunnel is created for the interoperability of the IPv4 and IPv6 addresses








ProfExam
PROFEXAM WITH A 20% DISCOUNT

You can buy ProfExam with a 20% discount..

Get Now!


HOW TO OPEN VCEX AND EXAM FILES

Use ProfExam Simulator to open VCEX and EXAM files
ProfExam Screen



HOW TO OPEN VCE FILES

Use VCE Exam Simulator to open VCE files
Avanaset