Download Troubleshooting Cisco Wireless Enterprise Network.pass4sures.300-370.2019-10-25.1e.72q.vcex


Download Exam

File Info

Exam Troubleshooting Cisco Wireless Enterprise Network
Number 300-370
File Name Troubleshooting Cisco Wireless Enterprise Network.pass4sures.300-370.2019-10-25.1e.72q.vcex
Size 7.12 Mb
Posted October 25, 2019
Downloads 19


How to open VCEX & EXAM Files?

Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.

Download
ProfExam Simulator

Purchase
Coupon: EXAMFILESCOM

Coupon: EXAMFILESCOM
With discount: 20%


ProfExam Simulator ProfExam Simulator ProfExam Simulator ProfExam Simulator ProfExam Simulator
 
 


Demo Questions

Question 1
While reviewing CleanAir data in Cisco Prime Infrastructure, an engineer notices that a wideband jammer is not sending its Interferer Security Trap correctly. The engineer determines that the default severity level has been changed. Which value does the engineer select to reset the severity level to its factory setting?

  • A: informational
  • B: major
  • C: minor
  • D: warning
  • E: critical
Correct Answer: D



Question 2
An engineer is using various techniques to discover and isolate rogues on the network. For which technique must the engineer consider legal ramifications?

  • A: rogue AP containment
  • B: RF detection
  • C: switch port tracing
  • D: wire detection
  • E: Cisco Prime Infrastructure location services
Correct Answer: A



Question 3
Which Cisco WLC debug command allows you to determine if the certificate process is failing in the CAPWAP messages?

  • A: debug pm pki enable
  • B: debug cert events enable
  • C: debug capwap events enable
  • D: debug capwap packet enable
  • E: debug capwap errors enable
Correct Answer: E



Question 4
Which channel width is the maximum that can be obtained by bonding two 802.11ac subchannels according to US regulations?

  • A: 160 MHz
  • B: 120 MHz
  • C: 84 MHz
  • D: 240 MHz
Correct Answer: A
To increase throughput, 802.11ac introduces two new channel widths. All 802.11ac devices are required to support 80 MHz channels, which doubles the size of the spectral channel over 802.11n. It further adds a 160 MHz channel option for even higher speeds. Due to the limitations of finding contiguous 160 MHz spectrum, the standard allows for a 160 MHz channel to be either a single contiguous block or two noncontiguous 80 MHz channels. 



Question 5
Refer to the exhibit. 

  
  
The AP is unable to join the controller. What is the cause of this error?

  • A: The controller code version is lower than the code of the AP attempting to join.
  • B: AP code is not the same as the controller and must download firmware.
  • C: AP model is not compatible with the controller code version.
  • D: The AP is not configured in the controller auth-list of acceptable APs.
Correct Answer: C



Question 6
Refer to the exhibit. 

  

Employees upgraded company issued iOS devices, which are configured to authenticate to the network using WPA2-Enterprise 802.1x with LEAP. As a result, the devices are no longer able to authenticate. Which action must the engineer do to resolve the issue?

  • A: Redeploy the existing configuration profile.
  • B: Change LEAP certificate on the ACS server.
  • C: Reset network settings on the devices.
  • D: Rejoin the enterprise network manually.
  • E: Deploy a new configuration profile with LEAP enabled.
Correct Answer: B



Question 7
Refer to the exhibit. 

  
  
Which statement about the join process of the access point is true?

  • A: The time on the controller is outside of the certificate's validity time interval, so the join phase failed.
  • B: The AP successfully joined the controller.
  • C: The AP moved from this controller to its primary controller.
  • D: The AP failed to join because the MAC address of the AP was not correct on the controller.
  • E: The controller rejected all discovery requests from the AP because they were not received on the management interface subnet.
Correct Answer: E



Question 8
Refer to the exhibit. 

  

A new wireless deployment with high AP density is experiencing high latency and connectivity issues on the 2.4 GHz band, despite an initial site survey done by a certified partner. Which option is the most impactful change a wireless consultant recommends?

  • A: Increase the fragmentation threshold to allow larger packets over the air.
  • B: Reduce the beacon period because it reduces the RF interference.
  • C: Disable lower data rates such as 1 Mbps and 2 Mbps.
  • D: Disable the short preamble.
  • E: Disable 802.11g support to reduce interference.
Correct Answer: C



Question 9
A wireless user is experiencing connectivity issues with their Mac OS laptop. If the Mac is exhibiting the behavior of a “sticky client,” how can the tech verify which AP the user is currently connected to?

  • A: Hold shift while clicking the wireless icon.
  • B: Hold option while clicking the wireless icon.
  • C: Hold control while clicking the wireless icon.
  • D: Hold command while clicking the wireless icon.
Correct Answer: B



Question 10
You have successfully configured HA and SSO using two Cisco 5508 Wireless LAN Controllers. You are able to access the Active Primary WLC but are unable to access the Secondary Standby WLC. Which two methods will allow you to access the standby unit? (Choose two.)

  • A: Via SSH to the Redundancy Management Interface.
  • B: Via Service Port Interface.
  • C: Via SSH to the Management Interface.
  • D: Via console connection.
Correct Answer: CD






CONNECT US


ProfExam
PROFEXAM WITH A 20% DISCOUNT

You can buy ProfExam with a 20% discount..

Get Now!


HOW TO OPEN VCEX AND EXAM FILES

Use ProfExam Simulator to open VCEX and EXAM files
ProfExam Screen



HOW TO OPEN VCE FILES

Use VCE Exam Simulator to open VCE files
Avanaset