Download Troubleshooting Cisco Data Center Infrastructure (DCIT).PracticeTest.300-180.2019-01-24.1e.80q.vcex

Download Dump

File Info

Exam Troubleshooting Cisco Data Center Infrastructure (DCIT)
Number 300-180
File Name Troubleshooting Cisco Data Center Infrastructure (DCIT).PracticeTest.300-180.2019-01-24.1e.80q.vcex
Size 4.04 Mb
Posted January 24, 2019
Downloads 3

How to open VCEX & EXAM Files?

Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.


With discount: 20%

Demo Questions

Question 1
View the Exhibit. 


Refer to the exhibit. Which statement about the topology is true?

  • A: Client 1, Client 2, and Client 3 are configured to have the default gateway IP address of
  • B: If Router A fails, the highest interface IP address backup router becomes the master.
  • C: Multiple VRRP groups are configured on each router.
  • D: Traffic to and from LAN clients is sent through the master router only.

Question 2
What is the default number of dynamic vNICs that is specified by the Cisco UCS Manager when creating a dynamic vNIC connection policy?

  • A: 257
  • B: 128
  • C: 256
  • D: 54

Question 3
Which two features are required to configure a blade to boot successfully from Fibre Channel? (Choose two.)

  • A: SAN connectivity policy
  • B: LUN masking
  • C: boot from SAN policy
  • D: port assignment
  • E: WWPN device alias

Question 4
View the Exhibit. 


Refer to exhibit A Cisco UCS admin is troubleshooting an issue with a vNIC not coming up on a blade. When looking at the CLI of the "Fabric Interconnect", the admin runs this command to view the status of the interface.  
Which option describes a possible reason why the interface is stuck in an "initializing" state?

  • A: The VLANs defined on the vNIC are not defined on a matching uplink port.
  • B: The MTU on the vNIC is higher than the MTU configured in the QoS system class.
  • C: The service profile is not applied to a blade.
  • D: The uplink port is down.

Question 5
Which solution can be applied if there is communication between hosts in different VLANS over Cisco OTV and the hosts are losing connectivity?

  • A: Increase the Cisco OTV CAM timers to match the ARP timer on any non-Nexus switches.
  • B: Configure an EEM script to clear MAC CAM tables on all devices every 25 minutes.
  • C: Move hosts so that they belong to the same VLAN.
  • D: Configure the ARP timers of any non-Nexus switches to be less than the Cisco OTV CA timer.

Question 6
In an IP storage environment, what occurs if you apply a service profile to a server that has an Ethernet-only mezzanine card?

  • A: The storage adapter is not visible to the OS.
  • B: The OS fails to boot.
  • C: A blade association occurs.
  • D: WWPN and WWNN are selected from the default pool.

Question 7
Which command would you use to check the status of your configuration synchronization peer?

  • A: N5K2# show peer status
  • B: N5K2# show config-sync peer
  • C: N5K2# show switch-profile peer
  • D: N5K2# show synch peer

Question 8
A customer is trying to boot an operating system that is installed on the eUSB on a Cisco UCS B-Series blade server, however, the boot fails. 
What is the cause of this failure?

  • A: eUSB support is available only on the Cisco UCS C-Series rack server.
  • B: The local disk must be the first device in the boot order.
  • C: eUSB is not the first device in the boot order for the server.
  • D: eUSB is not a supported boot device.

Question 9
Which two protocols are important for DCBX to enable the “no drop” classes that are needed for lossless transmission? (Choose two.)

  • A: PFC
  • B: ETS
  • C: FIP
  • D: LLDP
  • E: LACP

Question 10
Which two conditions can prevent FCoE from functioning properly across a link? (Choose two.)

  • A: LLDP is disabled.
  • B: PFC was negotiated across the link.
  • C: The VFC interface is down.
  • D: DCBX is enabled on the device.
  • E: The VSAN trunking protocol was enabled.



You can buy ProfExam with a 20% discount..

Get Now!


Use ProfExam Simulator to open VCEX and EXAM files
ProfExam Screen


Use VCE Exam Simulator to open VCE files