Download Cisco Certified Network Associate (200-301 CCNA).PremTest.200-301.2020-06-12.1e.90q.vcex
Download Exam
File Info
| Exam | Cisco Certified Network Associate (200-301 CCNA) |
| Number | 200-301 |
| File Name | Cisco Certified Network Associate (200-301 CCNA).PremTest.200-301.2020-06-12.1e.90q.vcex |
| Size | 3.59 Mb |
| Posted | June 12, 2020 |
| Downloads | 119 |
How to open VCEX & EXAM Files?
Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.
Coupon: EXAMFILESCOM
With discount: 20%
Demo Questions
Question 1
Refer to the exhibit. Which prefix does Router1 use for traffic to Host A?
- A: 10.10.10.0/28
- B: 10.10.13.0/25
- C: 10.10.13.144/28
- D: 10.10.13.208/29
Question 2
Which command automatically generates an IPv6 address from a specified IPv6 prefix and MAC address of an interface?
- A: ipv6 address dhcp
- B: ipv6 address 2001:DB8:5:112::/64 eui-64
- C: ipv6 address autoconfig
- D: ipv6 address 2001:DB8:5:112::2/64 link-local
Question 3
Which IPv6 address type provides communication between subnets and cannot route on the Internet?
- A: link-local
- B: unique local
- C: multicast
- D: global unicast
Question 4
What is a benefit of using a Cisco Wireless LAN Controller?
- A: It eliminates the need to configure each access point individually.
- B: Central AP management requires more complex configurations.
- C: Unique SSIDs cannot use the same authentication method.
- D: It supports autonomous and lightweight APs.
Question 5
Which action is taken by switch port enabled for PoE power classification override?
- A: If a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled.
- B: When a powered device begins drawing power from a PoE switch port, a syslog message is generated.
- C: As power usage on a PoE switch port is checked, data flow to the connected device is temporarily paused.
- D: If a switch determines that a device is using less than the minimum configured power, it assumes the device has failed and disconnects it.
Question 6
Which action must be taken to assign a global unicast IPv6 address on an interface that is derived from the MAC address of that interface?
- A: explicitly assign a link-local address
- B: disable the EUI-64 bit process
- C: enable SLAAC on an interface
- D: configure a stateful DHCPv6 server on the network
Question 7
Several new coverage cells are required to improve the Wi-Fi network of an organization. Which two standard designs are recommended? (Choose two.)
- A: 5GHz provides increased network capacity with up to 23 nonoverlapping channels.
- B: 5GHz channel selection requires an autonomous access point.
- C: Cells that overlap one another are configured to use nonoverlapping channels.
- D: Adjacent cells with overlapping channels use a repeater access point.
- E: For maximum throughput, the WLC is configured to dynamically set adjacent access points to the channel.
Question 8
What are two differences between optical-fiber cabling and copper cabling? (Choose two.)
- A: A BNC connector is used for fiber connections
- B: The glass core component is encased in a cladding
- C: The data can pass through the cladding
- D: Light is transmitted through the core of the fiber
- E: Fiber connects to physical interfaces using RJ-45 connections
Question 9
How does CAPWAP communicate between an access point in local mode and a WLC?
- A: The access point must not be connected to the wired network, as it would create a loop
- B: The access point must be connected to the same switch as the WLC
- C: The access point must directly connect to the WLC using a copper cable
- D: The access point has the ability to link to any switch in the network, assuming connectivity to the WLC
Question 10
Which IPv6 address block forwards packets to a multicast address rather than a unicast address?
- A: 2000::/3
- B: FC00::/7
- C: FE80::/10
- D: FF00::/12
HOW TO OPEN VCEX AND EXAM FILES
Use ProfExam Simulator to open VCEX and EXAM files
HOW TO OPEN VCE FILES
Use VCE Exam Simulator to open VCE files
