Download CCNA Cisco Certified Network Associate CCNA (v3-0).selftestengine.200-125.1e.571q.vcex

Download Dump

File Info

Exam CCNA Cisco Certified Network Associate CCNA (v3.0)
Number 200-125
File Name CCNA Cisco Certified Network Associate CCNA (v3-0).selftestengine.200-125.1e.571q.vcex
Size 26.56 Mb
Posted December 27, 2018
Downloads 117



How to open VCEX & EXAM Files?

Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.

Purchase
Coupon: EXAMFILESCOM

Coupon: EXAMFILESCOM
With discount: 20%





Demo Questions

Question 1
Which IPv6 address is the all-router multicast group?

  • A: FF02::1
  • B: FF02::2
  • C: FF02::3
  • D: FF02::4



Question 2
Refer to the exhibit. Which address range efficiently summarizes the routing table of the addresses for router Main? 

  

  • A: 172.16.0.0./21
  • B: 172.16.0.0./20
  • C: 172.16.0.0./16
  • D: 172.16.0.0/18



Question 3
Which IPv6 address is valid?

  • A: 2001:0db8:0000:130F:0000:0000:08GC:140B
  • B: 2001:0db8:0:130H::87C:140B
  • C: 2031::130F::9C0:876A:130B
  • D: 2031:0:130F::9C0:876A:130B



Question 4
Which command can you use to manually assign a static IPv6 address to a router interface?

  • A: ipv6 autoconfig 2001:db8:2222:7272::72/64
  • B: ipv6 address 2001:db8:2222:7272::72/64
  • C: ipv6 address PREFIX_1 ::1/64
  • D: ipv6 autoconfig



Question 5
Which of these represents an IPv6 link-local address?

  • A: FE80::380e:611a:e14f:3d69
  • B: FE81::280f:512b:e14f:3d69
  • C: FEFE:0345:5f1b::e14d:3d69
  • D: FE08::280e:611:a:f14f:3d69



Question 6
Refer to the exhibit. What is the meaning of the output MTU 1500 bytes? 

  

  • A: The maximum number of bytes that can traverse this interface per second is 1500.
  • B: The minimum segment size that can traverse this interface is 1500 bytes.
  • C: The maximum segment size that can traverse this interface is 1500 bytes.
  • D: The minimum packet size that can traverse this interface is 1500 bytes.
  • E: The maximum packet size that can traverse this interface is 1500 bytes.
  • F: The maximum frame size that can traverse this interface is 1500 bytes.



Question 7
On a corporate network, hosts on the same VLAN can communicate with each other, but they are unable to communicate with hosts on different VLANs. 
What is needed to allow communication between the VLANs?

  • A: a router with subinterfaces configured on the physical interface that is connected to the switch
  • B: a router with an IP address on the physical interface connected to the switch
  • C: a switch with an access link that is configured between the switches
  • D: a switch with a trunk link that is configured between the switches



Question 8
Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network. The network administrator connected to router Coffee via the console port, issued the show ip route command, and was able to ping the server.  
Based on the output of the show ip route command and the topology shown in the graphic, what is the cause of the failure? 

  

  • A: The network has not fully converged.
  • B: IP routing is not enabled.
  • C: A static route is configured incorrectly.
  • D: The FastEthernet interface on Coffee is disabled.
  • E: The neighbor relationship table is not correctly updated.
  • F: The routing table on Coffee has not updated.



Question 9
Host 1 is trying to communicate with Host 2. The e0 interface on Router C is down. Which of the following are true? (Choose two.) 

  

  • A: Router C will use ICMP to inform Host 1 that Host 2 cannot be reached.
  • B: Router C will use ICMP to inform Router B that Host 2 cannot be reached.
  • C: Router C will use ICMP to inform Host 1, Router A, and Router B that Host 2 cannot be reached.
  • D: Router C will send a Destination Unreachable message type.
  • E: Router C will send a Router Selection message type.
  • F: Router C will send a Source Quench message type.



Question 10
Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design? 

  

  • A: This design will function as intended.
  • B: Spanning-tree will need to be used.
  • C: The router will not accept the addressing scheme.
  • D: The connection between switches should be a trunk.
  • E: The router interfaces must be encapsulated with the 802.1Q protocol.









CONNECT US


ProfExam
PROFEXAM WITH A 20% DISCOUNT

You can buy ProfExam with a 20% discount..

Get Now!


HOW TO OPEN VCEX AND EXAM FILES

Use ProfExam Simulator to open VCEX and EXAM files
ProfExam Screen



HOW TO OPEN VCE FILES

Use VCE Exam Simulator to open VCE files
Avanaset