Download Cisco.PracticeDumps.100-105.2018-05-25.1e.345q.vcex

Download Exam

File Info

Exam Interconnecting Cisco Networking Devices Part 1 (ICND1 v3.0)
Number 100-105
File Name Cisco.PracticeDumps.100-105.2018-05-25.1e.345q.vcex
Size 30.09 Mb
Posted May 25, 2018
Downloads 236

How to open VCEX & EXAM Files?

Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.


With discount: 20%


Demo Questions

Question 1
Refer to the exhibit. 
Which command is simplest to configure routing between the regional office network and the corporate network?

  • A: router2(config)#ip route
  • B: router2(config)#ip route
  • C: router1(config)#ip route
  • D: router1(config)#ip route

Question 2
What is one requirement for interfaces to run IPv6?

  • A: An IPv6 address must be configured on the interface.
  • B: An IPv4 address must be configured.
  • C: Stateless autoconfiguration must be enabled after enabling IPv6 on the interface
  • D: IPv6 must be enabled with the ipv6 enable command in global configuration mode.

Question 3
Refer to the exhibit. 
The MAC address table is shown in its entirety. The Ethernet frame that is shown arrives at the switch. 
What two operations will the switch perform when it receives this frame? (Choose two.)

  • A: The switch will not forward a frame with this destination MAC address.
  • B: The frame will be forwarded out of all the ports on the switch.
  • C: The MAC address of ffff.ffff.ffff will be added to the MAC address table.
  • D: The frame will be forwarded out of all the active switch ports except for port fa0/0.
  • E: The MAC address of 0000.00aa.aaaa will be added to the MAC Address Table.
  • F: The frame will be forwarded out of fa0/0 and fa0/1 only.

Question 4
Which network topology allows all traffic to flow through a central hub?

  • A: bus
  • B: star
  • C: mesh
  • D: ring

Question 5
Which two statements are true regarding ICMP packets? (Choose two.)

  • A: They are encapsulated within IP datagrams.
  • B: They guarantee datagram delivery.
  • C: TRACERT uses ICMP packets.
  • D: They acknowledge receipt of TCP segments.
  • E: They are encapsulated within UDP datagrams.

Question 6
Which method does a connected trunk port use to tag VLAN traffic?

  • A: IEEE 802.1w
  • B: IEEE 802.1D
  • C: IEEE 802.1Q
  • D: IEEE 802.1p

Question 7
On which type of device is every port in the same collision domain?

  • A: a router
  • B: a Layer 2 switch
  • C: switch
  • D: a hub
  • E: a Layer 3 switch

Question 8
Which option is the default switch port port-security violation mode?

  • A: shutdown
  • B: protect
  • C: shutdown vlan
  • D: restrict

Question 9
Refer to the exhibit. 
An administrator cannot connect from R1 to R2. To troubleshoot this problem, the administrator has entered the command shown in the exhibit. 
Based on the output shown, what could be the problem?

  • A: The serial interface is configured for the wrong frame size.
  • B: The serial interface does not have a cable attached.
  • C: The serial interface has the wrong type of cable attached.
  • D: The serial interface has a full buffer.
  • E: The serial interface is configured for half duplex.

Question 10
Which statement about native VLAN traffic is true?

  • A: Cisco Discovery Protocol traffic travels on the native VLAN by default.
  • B: Traffic on the native VLAN is tagged with 1 by default.
  • C: Control plane traffic is blocked on the native VLAN.
  • D: The native VLAN is typically disabled for security reasons.


You can buy ProfExam with a 20% discount..

Get Now!


Use ProfExam Simulator to open VCEX and EXAM files
ProfExam Screen


Use VCE Exam Simulator to open VCE files